IPC 4101C PDF
IPCC Specification for Base Materials for Rigid and Multilayer Printed Boards August Supersedes IPCB with Amendments. Slash Sheets. Isola laminate and prepreg materials are certified to IPC or IPC IPC, “Specification for Base Materials for Rigid and Multi-layer. IPC Specification for Base Materials for Rigid and Multilayer Printed Boards.
|Published (Last):||21 May 2018|
|PDF File Size:||7.93 Mb|
|ePub File Size:||12.4 Mb|
|Price:||Free* [*Free Regsitration Required]|
Class A applies, unless otherwise speci? Title, number and revision letter of the speci? Bromine With or without inorganic?
IPCC: Specification for Base Materials for Rigid and Multilayer Printed Boards
Prepreg should be allowed to equilibrate at processing conditions before use. Focus on end product performance? E Reinforcement Style see 1. Steven Ethridge, Dell Inc.
Prior to testing, specimens shall be cleaned as follows: A completed IPC contains a pro? Applicable documents see Section 2.
One set of test information for laminate 0. Additional testing required by the user shall be included in the purchase order. Contain 4101cc that cannot be defended with data Notice IPC Standards and Publications are designed to serve the public interest through eliminating misunderstandings between manufacturers and purchasers, facilitating interchangeability and improvement of products, and assisting the purchaser in selecting and obtaining with minimum delay the proper product for his particular need.
Nominal thickness, width and length of material see 3. The longest dimension of each foil indentation in a specimen shall be measured with a suitable reticule on a minimum 4X magni?
IPC-4101C: Specification for Base Materials for Rigid and Multilayer Printed Boards
If the applicable speci? Adjacent edges shall be perpendicular within 0.
Examples to clarify the use of Keywords are shown below: For any alloy or other metals outside this density range, the appropriate factor must be used to calculate the foil thickness. The number of samples required per lot sampled shall also be ic speci?
Evidence of compliance to the speci? Specimens 75 mm x 75 mm [2.
The permissible variations from the speci? Nonwoven E-glass Core Secondary 2: The worst 50 mm x 50 mm [1.
IPC – Base Materials, Laminates
Information for preparation of delivery, if 4101cc see Section 5. The sheets shall be comprised of consecutive press loads of the same material covered by a single speci?
There shall be no evidence of resin-starved or scorched areas.
Types of acceptable markings are: Opaque foreign matter i;c than? Cladding type H can be used for type C and type S can be used for type R. Volatile content maximum 4. At elevated temperature 4. Creases with exposed reinforcement are 15 mm [0.
Requirements for CAF will be considered as a speci? Cellulose paper, Core Secondary 2: The specimen shall be tested in accordance with Table for prepregs.
All rights reserved under both international and Pan-American copyright conventions. When certifying to multiple speci?