FR E520 3.7K PDF
FR-EK to K(C). FR-EK to K(C) ○Removal. (For the FR- EK to K, FR-ESK to K, FR-EW-. K to K). FR-E FR-EKND to KND. INSTRUCTION MANUAL. OUTLINE Economy, Trade and Industry) in September, applies to the K and less. : USED MITSUBISHI FR-EK-NA,FR-PA INVERTER, 5hp, v,BOXYB: Everything Else.
|Published (Last):||9 February 2007|
|PDF File Size:||17.29 Mb|
|ePub File Size:||16.89 Mb|
|Price:||Free* [*Free Regsitration Required]|
Set any of the following values in Pr. Using the connection cable for operation 1 Remove the operation panel.
Apply only the voltage specified in the instruction manual to each terminal to prevent damage etc. PID forward action If the proportional band is narrow parameter setting is smallthe manipulated variable varies greatly with a slight change of the process value.
The optional brake resistor cannot be used with 0. The frequency setting signal is set using the operation panel or 3.7i unit.
Do not connect terminals SE Check that the following parameter settings are correct Pr. Fr-esc to sc-ene; fr-essc to sc-ene 38 pages. Name Company Telephone Email. While power is on or when the inverter is running, do not open the front cover.
Otherwise nearby electronic equipment may be affected. User Group Selection pr. By using the operation panel or parameter unit, you can calibrate a meter connected to terminal FM to full scale deflection.
At this time, Description all external contact inputs switch off. Not provided for the FR-E Regenerative Brake Duty pr.
FR-E Industrial Automation, Control | eBay
As soon as the regenerative energy has reduced, deceleration resumes. You s520 select the reset function input timing. Note that Chapter 4 they are not terminal names. The electronic thermal reray function does not guarantee protection of the motor from overheating. Page 20 – Removal of the operation panel front cov Terminal FM provides the pulse output. Corrective action Eliminate the cause of the error preceding this error indication.
MITSUBISHI EREQROL-E FR-EK INVERTER – PLC DCS SERVO Control MOTOR POWER SUPPLY IPC ROBOT
Please forward this manual to the end user. When entering 0 to 10VDC, always make this setting.
This manual also for: Relay 2 Check for rough 2 Visual check. Fan connector 3 Remove the inverter and cooling fan. Power supply harmonics are different in generation source, frequency band and transmission path from radio frequency RF noise and leakage currents. Make calibration using Pr. Motor need not be connected.
Page – Cooling fan operation selection Pr. Fr-e to – ec; fr-es to – ec pages. This function is used to prevent parameter values from ff rewritten by incorrect operation.
There is no cooling fan in the FR- E Dc Injection Brake pr. While power is on and for some time after power-off, e5200 not touch the inverter or brake resistor as they are hot and you may get burnt.
Therefore, fix the motor securely with a mechanical brake, or before tuning, make sure that there e5220 be no problem in safety if the motor runs. Terminal SD is common to the contact input signals.